All Side Welded Barrels

All Side Welded Barrels are supplied for highly hazardous Chemicals and high value products. The general Specification remain the same. However top and bottom of barrels are welded in addition to seeming operation which is done for standard barrels and makes the barrels 100% leakage proof.

Uses: These barrels are specially used for extremely hazardous products to ensure no leakages.

  • Thickness: 22 G to 16 G
  • Capacity: 100ltr to 250ltr

200 Ltr

Specification
PARAMETERS SPECIFICATION PARAMETER SPECIFICATION
TYPE OF DRUM TRIPPLE SEAMED, SIDEAND ENDS WELDED.DRUM NARROW MOUTH TWO BUNGS BARREL INTERNAL HEIGHT OF 856±2mm
MATERIAL OF CONSTRUCTION CRCA MS SHEET OUTER HEIGHT OF 890±2mm
OD AT TOP 586±2mm
OD AT MIDDLE 571±1mm
GRADE OF STEEL DSK / OSK OD AT BOTTOM 586±1mm
THICKNESS OFSTEEL IN SHELL (IN MM) :   0.8 / 1.0 / 1.2 / 1.6 No. OF FLANGE & BUNGS Two
THICKNESS OF STEEL AT TOP (IN MM) :   0.8 / 1.0 / 1.2 / 1.6 ID OF FLANGE – I (2INCH) 2”
THICKNESS OF STEEL AT BOTTOM (IN MM) :   0.8 / 1.0 / 1.2 / 1.6 Wt. OF BUNG I 64±3gm
GRADE / MATERIAL OF SEAMING COMPOUND AS REQUIRED ID OF FLANGE- II (3/4INCH) ¾”
COLOUR OF DRUM SYNTHETIC ENAMEL / STOVING ENAMEL Wt. OF BUNG II 20±3gm
SCRATCH HARDNESS OFBETWEEN TWOGALVANISED LAYER DISTANCE BETWEEN TWO BUNGS 435±6mm
GLOSS LEVEL OF GALVANISED LAYER High TARE Wt. OF DRUM (KGS) :   16 / 18 / 19.5 / 21.5 / 24 / 28
GLOSS RETENTION OF GALVANISED LAYER Good OVER FLOW CAPACITY OF DRUM 216 lit
No. OF CORRUGATION AT TOP AND BOTTOM SECTION OF SHELL, IF ANY For on both side( if required ) LEAKAGE TEST 0.5kg/m2 air pressure 2kg/m2 air pressure
TYPE OF ROLLING HOOPS USUAL / MULTIPLE DROP TEST 1.5 mtr
HEIGHT OF ROLLING HOOPS 585±1mm out to out DEPTH AT TOP HEAD 17±1mm
DISTANCE BETWEEN TWO ROLLING HOOPS :   279 ± 5 mm DEPTH AT BOTTOM HEAD 17±1mm